Installation on UNIX systems

This section will guide you through the general configuration and installation of PHP on Unix systems. Be sure to investigate any sections specific to your platform or web server before you begin the process.

Prerequisite knowledge and software:

There are several ways to install PHP for the Unix platform, either with a compile and configure process, or through various pre-packaged methods. This documentation is mainly focused around the process of compiling and configuring PHP.

The initial PHP setup and configuration process is controlled by the use of the commandline options of the configure script. This page outlines the usage of the most common options, but there are many others to play with. Check out the Complete list of configure options for an exhaustive rundown. There are several ways to install PHP:

Apache Module Quick Reference

PHP can be compiled in a number of different ways, but one of the most popular is as an Apache module. The following is a quick installation overview.

Example 3-2. Quick Installation Instructions for PHP 4 (Apache Module Version)

1.  gunzip apache_1.3.x.tar.gz
2.  tar xvf apache_1.3.x.tar
3.  gunzip php-x.x.x.tar.gz
4.  tar xvf php-x.x.x.tar
5.  cd apache_1.3.x
6.  ./configure --prefix=/www
7.  cd ../php-x.x.x
8.  ./configure --with-mysql --with-apache=../apache_1.3.x --enable-ftp
9.  make
10. make install
11. cd ../apache_1.3.x
12. ./configure --activate-module=src/modules/php4/libphp4.a
13. make
14. make install
15. cd ../php-x.x.x
16. cp php.ini-dist /usr/local/lib/php.ini
17. Edit your httpd.conf or srm.conf file and add: 
      AddType application/x-httpd-php .php

18. Use your normal procedure for restarting the Apache server. (You must
    stop and restart the server, not just cause the server to reload by
    use a HUP or USR1 signal.)

Building

When PHP is configured, you are ready to build the CGI executable. The command make should take care of this. If it fails and you can't figure out why, see the Problems section.