THE UNIVERSITY OF BRITISH COLUMBIA
 
Science 1 Physics Assignment # 15:
 
CURRENT, RESISTANCE & DC CIRCUITS
 
Wed. 07 Feb. 2001 - finish by Wed. $\heartsuit$ 14 Feb. $\heartsuit$

1.
TRIUMF POWER USE: The electromagnet that generates the magnetic field for the world's largest cyclotron at TRIUMF has conductors made of aluminum ( $\rho = 2.8 \times 10^{-8}$ $\Omega$m) wound in a circle of radius 9.5 m. The conductor has a rectangular cross section (2.5 cm $\times$ 42 cm). There are 15 turns in the top half of the magnet and 15 in the bottom half, for a total length of 30 circumferences (the top and bottom coils are connected in series). If we apply 100 V to the coils, what current flows through it? How much power does this require to run?

2.
RC CIRCUIT TIME-DEPENDENCE:

\begin{figure}\begin{center}\mbox{
\epsfysize 1.333in \epsfbox{PS/29-46.ps} } \end{center} \end{figure}

In the circuit shown, ${\cal E} = 1.2 $ kV, C = 6.5 $\mu$F and R1 = R2 = R3 = R = 0.73 M$\Omega$. With C completely uncharged, switch S is suddenly closed (at t=0).
(a)
Determine the currents through each resistor for t=0 and $t=\infty$.
(b)
Draw a qualitative graph of the potential difference V2 across R2 as a function of time from t=0 and $t=\infty$.
(c)
What are the numerical values of V2 at t=0 and $t=\infty$?
(d)
Give the physical meaning of ``$t=\infty$'' in this case.
(e)
Finally, write down expressions for the currents through R1, R2 and R3 as functions of time, in terms of C and R.

. . . and Tipler (4$^{\rm th}$ Edition)

Ch. 26: problems 31, 91, 110, 137 and 153

Challenge Problems:

1.
DISTRIBUTED LOAD: A power transmission line (for instance) can be modelled as an array of discrete resistors such as that shown below. If the array continues indefinitely to the right, what is the effective resistance between A and B?

\begin{figure}
\epsfysize 1.0in
\begin{center}\mbox{
\epsfbox{PS/line_of_resistors.ps} %
}\end{center}\end{figure}

2.
Review: FIELD WITHIN A UNIFORM CHARGE DISTRIBUTION

You have seen how to use GAUSS' LAW to derive the radial (r) dependence of the electric field E(r>R) outside charge distributions of spherical, cylindrical or planar symmetry, where R is the distance the charge distribution extends from the centre of symmetry - the radius of a charged sphere or cylinder, or half the thickness of an infinite slab of charge, respectively. Use similar arguments to show that, for each of these cases (a sphere, cylinder or a slab of uniform charge density), the electric field E(r<R) inside the charge distribution is given in terms of the field E(R) at the boundary of the charge distribution by

\begin{displaymath}E(r<R) = \left( r \over R \right) E(R) . \end{displaymath}



Jess H. Brewer
2001-02-07